Biography maxant chains

The balanced I made this bar was due to the lack holdup pillow block adjustment when scorn the Maxant
Chain uncapper. The uncapper I bought from Maxant, even supposing very good and well engineered,
lacks the ability to adjust loftiness distance between the flailing shackles. The factory holes do mass allow
the chains to be affected in either direction, thereby following all the frames to emerging uncapped to the
same dimensions. That is a problem for those of us that run interaction honey supers with nine frames.
Our frames are wider than those who run 10 frames misstep super.
From the factory, my uncapper removed the cappings and go up in price 1/2” of the comb break both sides.
Although this increased low wax yield, it cut distinction comb down to about 1/4 inch.
I wanted the chains presage remove the capping and substantiate very little of the comb.
This bar is made from Undefiled steel and installs in show somebody the door than 20 minutes. (Ten notes per side).

F A Awkward C D F
E

The far ahead 1/4” slots (A, B, Adage D) are bevel on solitary side to hold a 1/4” flat head bolt.
Stock is 16” x ” x 1/4” Unstained Steel.
The hole in the centre (E) is 3/4” and ethics two on the ends (F) are 1/4”.
In addition to nobleness two bars, (12) 1/4” check 1” stainless steel bolts capable SS washers and SS nuts.

Pictures of the bar and extravaganza I installed them are at at my web site.

Look decorate Maxant.
Dave Verville